Flat pack furniture assembly in Feltham

Measure from the floor and from a wall corner to the socket, cable entry or outlet that must stay accessible. Compare the finished unit’s depth with the depth of the plugs and the cable bend. Some media units have a solid rear panel and some have a factory opening. Share the model and any assembly drawings rather than assuming an opening can be added during a standard build.

Clear the room before the appointment and move loose electrical equipment off the floor. Label the cables that must reach behind the finished furniture. You can then show the fitter which openings must stay clear without asking them to move connected equipment. Tell us whether the media unit is going against skirting, beside a chimney breast or between units that already stand in place.

A freestanding cabinet does not always sit flush to a wall. Measure any projection behind it and compare the positions of the legs and doors with the room layout. If you want to leave space to remove a plug, mark it on the sketch. Check the furniture and equipment instructions for any clearance or ventilation requirements before deciding which compartment to use.

Where your flat is reached through a managed service lane or a building above shops, confirm the door a contractor can use and the place where cartons may be unloaded. Give the floor, reception contact and any booking reference needed for the lift. Tell us if the retailer’s entrance differs from the entrance for the fitter.

The lift doorway and the space inside can be different sizes. Measure both before promising that a long cabinet carton can reach the room. If there is a sharp turn between reception and the lift, include it in your measurements. Do not leave packs across a shared access route. Ask where the building permits them to wait if the retailer delivers early.

If the closest place to unload is not the place to park, give the two locations and say how far apart they are. Check the signs for the relevant time, particularly on a route shared with shops or another building. Tell us if you have access to a private bay and who has confirmed it can be used for the fitting visit.

For cabinets with adjustable shelves, choose which compartments will take equipment or taller items. Check the usable internal width and depth after allowing for hinges and cabling. Mark the position of the shelves on the order or tell the fitter before the door fronts go on. A shelf that looks easy to move in a drawing may be harder to reach once the unit sits beside other furniture.

Compare the door and shelf carton references against the purchase list. If the unit was sold with several finishes, make sure the cartons correspond to the model you chose. Keep the hinge packs and runner packs separate if the order includes a chest of drawers. If the retailer has supplied an incorrect panel, save the label and photograph it before returning the pack.

Let us know where the old furniture is and whether it has to be dismantled. Empty the drawers and remove cables beforehand. If the room also has a new table or bookcase to assemble, decide which piece needs to be in use first. We can discuss a sequence that leaves room to unpack the longer parts before the completed units occupy the floor.

Hounslow Council parking information